WATER & PLUMBING

Pipe velocity.

Calculate average water velocity from flow rate and the inside diameter of a full pipe. Use the result to compare alternatives, not to certify pipe sizing.

Input guide & diagram
inside daverage velocity

Use clear inside dimensions and average velocity. Nominal DN/NPS is not inside diameter.

Explore unit converters →
PIPE VELOCITY

Need help? Select ? beside an input.

?

Volume moving each unit of time. Check the selected unit: m³/h is per hour, while L/s is per second.

?

Measure the inside diameter. A nominal pipe size such as DN50 is not necessarily a 50 mm inside diameter.

Use a decimal point, for example 12.5.

Average liquid speed
1.52788745368m/s

Cross-sectional area: 0.00196349540849 m²

The pipe is assumed completely full. Pump pressure and pipe friction are not calculated here.

Try an example
Formula and assumptions
v = 4Q / (πd²)

Full circular pipe with steady flow and average cross-sectional velocity.

Use inside diameter; nominal DN or NPS is not an inside diameter.

This does not size partially filled gravity drainage, calculate friction loss or assess plumbing code compliance.

Inputs are converted to base units before calculation. Display uses 12 significant digits; accuracy depends on measurements and assumptions. Circular geometry uses an approximate value of π.

Practical guide
TRY THE NUMBERS

Practical examples

Worked example

A flow of 3 L/s through a full pipe with 50 mm inside diameter gives approximately 1.528 m/s. Keep the same flow and increase diameter to reduce velocity.

READ THE RESULT

How to read the result

  • The result is mean velocity over the cross-section. It does not show the local velocity at every point.
  • Check flow units: 1 L/s = 3.6 m³/h. Use inside diameter rather than outside diameter.
  • A suitable velocity depends on the application and design requirements. This tool does not check noise, erosion or water hammer.

Frequently asked questions

Why does a smaller pipe produce a higher velocity?

For the same flow, a smaller area needs higher velocity: v = Q/A.

Can I use this for an open channel or a half-full drain?

No. Those cases require the actual wetted area and an appropriate flow model; this tool assumes a full circular pipe.

UNITNEX

Calculation report

Use your browser's print destination to print or save as PDF.

Install UnitNex

Unit converters and calculators in a dedicated app window.

Choose the install icon in Chrome’s address bar or the install option in its menu. On iPhone or iPad, open UnitNex in Safari and choose Share → Add to Home Screen.

Calculations need an internet connection.