HVAC / VENTILATION

Air velocity.

Calculate average air velocity from airflow and internal duct dimensions. Check the chosen units before comparing different ducts.

Input guide & diagram
Inside dimensions: diameter for a round duct, width and height for a rectangular duct diameterwidthheight

Use clear inside dimensions and average velocity. Nominal DN/NPS is not inside diameter.

Explore unit converters →
AIR VELOCITY

Need help? Select ? beside an input.

?

Volume moving each unit of time. Check the selected unit: m³/h is per hour, while L/s is per second.

?

Use the clear inside width. Room dimensions use the same unit for length, width and height.

?

Use the clear inside height. Room dimensions use the same unit for length, width and height.

?

Measure the inside diameter. A nominal pipe size such as DN50 is not necessarily a 50 mm inside diameter.

Use a decimal point, for example 12.5.

Average air speed
5m/s

Cross-sectional area: 0.1 m²

This is average speed across the duct, rather than a speed measured at one point.

Try an example
Formula and assumptions
v = Q ÷ A; circle A = πd²/4; rectangle A = w × h

Steady volumetric airflow and average velocity at the same gas conditions.

Use internal duct dimensions. Calculated duct sizes are theoretical, not rounded to manufactured sizes.

This does not calculate pressure loss, fan selection, mixing efficiency or ventilation compliance.

Inputs are converted to base units before calculation. Display uses 12 significant digits; accuracy depends on measurements and assumptions. Circular geometry uses an approximate value of π.

Practical guide
TRY THE NUMBERS

Practical examples

Worked example

Flow 1800 m³/h is 0.5 m³/s. Through a 400 × 250 mm duct, area 0.1 m², average velocity is 5 m/s.

READ THE RESULT

How to read the result

  • The same flow moves faster through a smaller section.
  • This is section-average velocity; local readings may differ.
  • Velocity alone does not determine noise, pressure loss or ventilation suitability.

Frequently asked questions

Should I enter m³/h or m³/s?

Either supported unit works. Select the unit printed with your flow value; the tool converts it.

Is there one correct velocity for every duct?

No. The target depends on use, noise, losses and installation requirements.

UNITNEX

Calculation report

Use your browser's print destination to print or save as PDF.

Install UnitNex

Unit converters and calculators in a dedicated app window.

Choose the install icon in Chrome’s address bar or the install option in its menu. On iPhone or iPad, open UnitNex in Safari and choose Share → Add to Home Screen.

Calculations need an internet connection.